176 / Programming Hunt Groups
Compact ICS 6.1 System Coordinator Guide P0603544 02
5. Press
CHANGE
to set the mode:
Sequential
,
Rotary
,
Broadcast
.
6. Press
to exit or
‘
to continue programming.
Setting the hunt delay
This setting allows you to program the number of rings the system permits
at a Hunt Group set before moving on to the next telephone in the Hunt
Group.
1. At
Hunt groups
, press
≠
. The display shows
Show group
.
2. Enter the Hunt Group number you want to program (1-6) or press
‘
to scroll through the groups.
3. Press
≠
. The display shows
Member DNs:
.
4. Press
‘
until the display shows
Hunt delay
.
5. Press
CHANGE
to select the setting:
1, 2, 3, 4, 5, 6, 7, 8, 9, 10
.
6. Press
to exit or
‘
to continue programming.
Programming busy line setting
A Hunt Group is considered busy if either of these two scenarios exist:
• all of its members are being presented an incoming Hunt Group call
• all of its members are active on a Hunt Group call
There are three routing options if all members are busy:
• BusyTone—the caller gets a busy tone
• Overflow—the call is routed to an overflow position
• Queue—the call stays in the system for a period of time. Within this
period of time, the call is presented to a member if one becomes
available. When the time-out occurs, the call is presented to an
overflow position.
1. At
Hunt groups
, press
≠
. The display shows
Show group
.
2. Enter the Hunt Group number you want to program (1-6) or press
‘
to scroll through the groups.