Filter
Top Products
Changing a Block of Extensions (without Extension
Length Change)
Issue 1 June 2000
B-9
13. Determine your next step:
■ If you need to change a block of extension numbers without
changing the extension length, continue with “Changing a Block of
Extensions (without Extension Length Change).
■ If you are finished changing extensions, continue with “Release the
Voice Ports,” page B-5.
Changing a Block of Extensions
(without Extension Length Change)
Change a block of extensions from one series of numbers to another as follows:
1. Read the precautions that are given starting on page B-1.
2. For each system (remote or local) that needs to have a new range defined
to accommodate the intended new block of extensions do the following.
Access the AUDIX change machine name screen and define an address
range that includes the new block of extensions.
NOTE:
Be sure to perform this step first. If all machines are prepared for the
change, service across the network will be little affected.
3. From the Lucent INTUITY Administration menu, select AUDIX Administration.
4. At the enter command: prompt, enter either:
The system displays the Change Extensions screen (Figure B-5):
Full Command Version Short Command Version
change extensions ch e