Filter
Top Products
Test Each Channel
Issue 1 June 2000
A-11
Figure A-10. System Monitor Screen Showing Channel being Tested with INTUITY
ChanTran Touch To ne Recognition
2. Verify that all purchased and activated voice channels are listed as being
on-hook at the start of the testing.
3. Use a test phone to dial the extension number of the channel to be tested.
Begin with the extension assigned to channel 0.
The system responds:
“This is the channel and transfer test program.
You are testing voice channel number xx
1
.
Press 1 to initiate the touch tone recognition test.
Press 2 to initiate the call transfer test.
Press 3 to initiate the record and playback test or press the star
key to quit.”
NOTE:
ChanTran features dial-through which allows you to enter numbers or
commands before the message or the prompt stops playing.
Dial-through, however, can only be used in ChanTran testing after
ChanTran has reported the number of the channel being tested.
4. Verify that the channel number reported by ChanTran correctly matches
the channel associated with the extension that you dialed.
5. Verify that the channel is listed as ChanTran Talking on the system monitor
screen, as shown in Figure A-10 above. In this figure, Channel 4 is being
tested for touch tone recognition.
1. xx indicates the number of the channel being tested. For example, if channel 4 were being
tested, you would hear: “You are testing voice channel number 4”.