Filter
Top Products
Channel Mapping
A-4 Issue 1 June 2000
An information screen appears confirming that the switch extension has
been mapped to the channel.
9. Press to continue.
NOTE:
The Voice Equipment screen is not updated until the Channel to PBX
Extension screen is closed. If you wish to verify your mapping at any
time during the procedure, press the (Cancel) key twice to cancel
out of the Channel to PBX Extension and the Assign screen. This will
cause the INTUITY system to redraw the Voice Equipment screen.
10. Repeat Steps 6 through 9 for each channel that needs a switch extension.
11. Press (Cancel) until you reach the INTUITY Administration menu.
12. Return to Task 10, "Administer the Lucent INTUITY System for Operation
with the MERLIN LEGEND" on page 2-32.
Verify Channel State
The procedure is used to verify that the state of the channel is in-service (Inserv)
and that the channels are ready to be tested.
The INTUITY system has four possible port states:
■ In-Service (Inserv)
Channel is ready to accept telephone calls. There may be active calls on
this channel if the system is operational.
■ Facility-out-of-service (Foos)
The channel is not inservice. The Foos state occurs when a channel has
been released through the Voice Board Diagnostics screen to Inserv, and
it does not detect loop current. A channel in the Foos state should
automatically convert to the Inserv state when it detects loop current, but it
may need to be reset.
■ Manually-out-of-service (Manoos)
The channel has been busied-out under the Voice Board Diagnostics
screen, or the channel is on a new IVC6 circuit card. A channel in the
Manoos state will remain in the Manoos state until it is released under the
Voice Board Diagnostics screen.
■ Non-Existent (NONEX or no entry on any screen)
The system does not see the channel. The system will not see a channel
that has not been properly activated even if the IVC6 is present. To change
a channel from non-existent to recognized, the remote maintenance
center must activate it.
ENTER
F6
F6