Filter
Top Products
2-6 Issue 1 June 2000
Task 4 - Make an Attended Back-up Tape
This procedure creates a back-up tape that can contain the system data, AUDIX
names, announcements, greetings, and messages for the Lucent INTUITY
system. Verify with your remote maintenance center which information should be
backed up for this customer.
NOTE:
Do not use a tape size smaller than 525 Mbytes with the Lucent INTUITY
system. Tapes smaller than 525 Mbytes will cause the backup to fail. If the
system is equipped with a 2-Gbyte tape drive, use either a 525 or a 2-
Gbyte tape.
To make an attended backup tape:
1. Locate the tape drive.
■ On the MAP/5, the tape drive is located at the front of the system, to
the right, behind the sliding door.
■ On the MAP/40, the tape drive is located on the front of the
computer, near the top, under the top cover.
■ On the MAP/100, the tape drive is located inside the right door,
near the top.
2. Remove the nightly backup tape:
■ If the tape is visible in the tape drive, press the tape in toward the
tape drive and then release. This action will release the tape.
■ If the tape drive has a door that conceals the tape, press the small
button on the upper right-hand corner of the tape drive to open the
tape drive door. The tape will slide out as the door opens.
3. Store the nightly backup tape in a safe place. Do not place the tape near
any magnetized components.
4. From the Customer/Services Administration screen, select:
The system displays the Backup screen (Figure 2-4).
> Backup
> Backup/Restore