6
ATA Administration Guide 94
Configuring the PSTN (FXO) Gateway on the
SPA3102
This chapter describes how to configure the PSTN gateway on the SPA3102.
• ”Connecting to PSTN and VoIP Services” section on page 94
• ”How VoIP-To-PSTN Calls Work” section on page 95
• ”How PSTN-To-VoIP Calls Work” section on page 98
• ”Configuring VoIP Failover to PSTN” section on page102
• ”Sharing One VoIP Account Between the FXS and PSTN Lines” section on
page103
• ”Other Options” section on page104
• ”Call Scenarios” section on page105
Connecting to PSTN and VoIP Services
The SPA3102 has the following ports for connection to telephony devices:
• FXS port (Phone)—Connect to a standard analog telephone or fax machine,
configured by using the Line page.
• FXO port (Line)—Connect to a standard telephone wall jack for connectivity to
the PSTN, configured using the PSTN Line page.
Line 1 does not provide a gateway because it provides only VoIP service. The
VoIP-To-PSTN calling function is referred to as a
PSTN gateway
, and the PSTN-To-
VoIP calling function is referred to as a
VoIP gateway
.
Note the following definitions:
• VoIP caller—One who calls the ATA device via VoIP to obtain PSTN service