Filter
Top Products
ATA Voice Field Reference
PSTN Line page (SPA3102)
ATA Administration Guide 197
B
Voice tab > PSTN Line page >
Subscriber Information section
Proxy Fallback Intvl This parameter sets the delay (sec) after which the PAP2T
will retry from the highest priority proxy (or outbound
proxy) servers after it has failed over to a lower priority
server. This parameter is useful only if the primary and
backup proxy server list is provided to the PAP2T via DNS
SRV record lookup on the server name. (Using multiple
DNS A record per server name does not allow the notion of
priority and so all hosts will be considered at the same
priority and the PAP2T will not attempt to fall back after a
fail over).
The default is 3600
Proxy Redundancy
Method
The PAP2T makes an internal list of proxies returned in
DNS SRV records. In normal mode this list will contain
proxies ranked by weight and priority.
If the parameter
Based on SRV port
is configured, the
PAP2T creates a list in normal mode first, and then inspects
the port numbers based on the 1
st
proxy’s port on the list.
The default is Normal.
Display Name Display name for caller ID.
User ID Extension number for this line.
Password Password for this line.
Use Auth ID To use the authentication ID and password for SIP
authentication, select yes. Otherwise, select no to use the
user ID and password.
The default is no.
Auth ID Authentication ID for SIP authentication.
Call Capacity Maximum number of calls allowed on this line interface.
Choices: {unlimited,1,2,3,…25 }. Default is 16. Note that the
ATA device does not distinguish between incoming and
outgoing calls when talking about call capacity.
NOTE: unlimited = 16