Filter
Top Products
ATA Voice Field Reference
Regional page
ATA Administration Guide 148
B
Voice tab > Regional page >
Distinctive Ring Patterns section
Holding Tone Informs the local caller that the far end has placed the call
on hold.
The default is 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1).
Conference Tone Played to all parties when a three-way conference call is in
progress.
The default is 350@-19;20(.1/.1/1,.1/9.7/1).
Secure Call
Indication Tone
Played when a call has been successfully switched to
secure mode. It should be played only for a short while
(less than 30 seconds) and at a reduced level (less than -19
dBm) so it does not interfere with the conversation.
The default is 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/
2).
VoIP PIN Tone Specification of the tone played to prompt a VoIP caller for
a PIN number (if PIN authentication is selected and the
caller requires authentication to use the PSTN gateway).
This setting applies to the SPA3102 only.
The default is 600@-10;*(0/1/1,.1/.1/1,.1/.1/1,.1/.5/1).
PSTN PIN Tone Specification of the tone played to prompt a PSTN caller
for a PIN number (if PIN authentication is selected and the
caller requires authentication to use the VoIP gateway).
This setting applies to the SPA3102 only.
The default is 600@-10;*(0/.7/1,.2/.1/1,.2/.1/1,.2/.5/1).
Feature Invocation
Ton e
Played when a feature is implemented.
The default is 350@-16;*(.1/.1/1).
This field is not found in the PAP2T.
Ring1 Cadence Cadence script for distinctive ring 1.
The default is 60(2/4).
Ring2 Cadence Cadence script for distinctive ring 2.
The default is 60(.3/.2, 1/.2,.3/4).