Filter
Top Products
Basic Administration and Configuration
Using the Administration Web Server
ATA Administration Guide 40
2
STEP 3 Complete the WAN configuration for DHCP, static IP addressing, or PPPoE.
For DHCP:
a. Select DHCP from the
Connection Type
drop-down menu.
b. If you use a cable modem, you may need to configure the MAC Clone Settings.
(Contact your ISP for more information.)
c. If your service uses a specific PC MAC address, then select yes from the
Enable MAC Clone Service
setting.
d. Then enter the PC’s MAC address in the
Cloned MAC Address
field.
For Static IP Addressing:
a. Select Static IP from the
Connection Type
drop-down menu.
b. In the Static IP Settings section, enter the IP address in the
Static IP
field, the
subnet mask in the
NetMask
field, and the default gateway IP address in the
Gateway
field.
c. In the Optional Settings section, enter the DNS server address(es) in the
Primary DNS
and optional
Secondary DNS
fields.
For PPPoE:
a. Select PPPoE from the
Connection Type
drop-down menu. This is the correct
setting for most DSL users.
b. Enter the values provided by the ITSP in the following fields:
• PPPoE Login Name
• PPPoE Login Password
• PPPoE Service Name
STEP 4 Click Submit All Changes. The ATA device reboots.
STEP 5 To verify your progress, click the Router tab and then click Status. Under
System
Status
, confirm the
WAN Connection Type
,
Current IP
,
Current Netmask
,
Current
Gateway
, and
Primary DNS
.