Filter
Top Products
Configuring Voice Services
SIP Trunking and Hunt Groups on the SPA8000
ATA Administration Guide 86
4
The Trunk Status page shows all calls that are currently active on each trunk
group.
This page shows a snapshot of the trunk activity. You can refresh the data at any
time by clicking the Refresh button on the web browser toolbar. The page shows
the following information:
• External: The called number
• Station: The SPA8000 line that is in use for this call
• Direction: The direction of the call, either Outbound or Inbound
• State: The state of the call
• Calling: An outbound call was initiated but is not ringing at the other end.
• Proceeding: The outbound call is ringing at the other end.
• Ringing: An inbound call is ringing.
• Connected: The call is connected.
• Duration: The duration of the call
In the case of a hung call, you can select the check box for the call and then click
the Delete button to cancel the call.
Setting the Hunt Policy
You can configure the SPA8000 so that the hunt rule applies to all phone or only to
the phones that are on hook.
STEP 1 Connect to the administration web server, and choose Admin access with
Advanced settings.
STEP 2 Click Voice tab > SIP.
STEP 3 Scroll down to the Trunking Parameters section.
STEP 4 In the Hunt Policy field, choose the desired option:
• onhook only: The hunt includes only the phones that are on hook.
• any state: The hunt includes all phones regardless of the state.
STEP 5 Click Submit All Changes.