Filter
Top Products
ATA Voice Field Reference
User page
ATA Administration Guide 213
B
User page
Depending on the model of ATA device, there may be one or more User pages.
You can use this page to configure the user settings. This page includes the
following sections:
• ”Call Forward Settings section” section on page 214
• ”Selective Call Forward Settings section” section on page 215
• ”Speed Dial Settings section” section on page 215
• ”Supplementary Service Settings section” section on page 216
• ”Distinctive Ring Settings section” section on page 217
• ”Ring Settings section” section on page 218
NOTE For the SPA8000, the settings on this page occur on each Line tab ([1] to [8]).
When a call is made from Line 1 or Line 2, the ATA device shall use the user and
line settings for that line; there is no user login support. Per user parameter tags
must be appended with [1] or [2] (corresponding to line 1 or 2) in the configuration
profile. It is omitted below for readability.
Ring Threshold Choose from {13.5–16.5, 19.35–2.65, 40.5–49.5} (Vrms).
The default is 13.5-16.5 Vrms.
Ringer Impedance Choose from {High, Synthesized(Poland, S.Africa,
Slovenia)}.
The default is high.
Line-In-Use Voltage Determines the voltage threshold at which the SPA-3000
assumes the PSTN is in use by another handset sharing the
same line (and will declare PSTN gateway service not
available to incoming VoIP callers).
The default value is 40v.