Filter
Top Products
ATA Voice Field Reference
Regional page
ATA Administration Guide 152
B
Hook Flash Timer
Max
Maximum on-hook time before off-hook qualifies as hook-
flash. More than this the on-hook event is treated as on-
hook (no hook-flash event). Range: 0.4–1.6 seconds.
The default is 0.9.
Callee On Hook
Delay
Phone must be on-hook for at this time in sec before the
ATA device will tear down the current inbound call. It does
not apply to outbound calls. Range: 0–255 seconds.
The default is 0.
Reorder Delay Delay after far end hangs up before reorder tone is played.
0 = plays immediately, inf = never plays. Range: 0–255
seconds.
The default is 5.
Call Back Expires Expiration time in seconds of a call back activation. Range:
0–65535 seconds.
The default is 1800.
Call Back Retry
Intvl
Call back retry interval in seconds. Range: 0–255 seconds.
The default is 30.
Call Back Delay Delay after receiving the first SIP 18x response before
declaring the remote end is ringing. If a busy response is
received during this time, the ATA device still considers the
call as failed and keeps on retrying.
The default is 0.5.
VMWI Refresh Intvl Interval between VMWI refresh to the CPE.
The default is 0.5.
Interdigit Long
Timer
Long timeout between entering digits when dialing. The
interdigit timer values are used as defaults when dialing.
The Interdigit_Long_Timer is used after any one digit, if all
valid matching sequences in the dial plan are incomplete
as dialed. Range: 0–64 seconds.
The default is 10.
Interdigit Short
Timer
Short timeout between entering digits when dialing. The
Interdigit_Short_Timer is used after any one digit, if at least
one matching sequence is complete as dialed, but more
dialed digits would match other as yet incomplete
sequences. Range: 0–64 seconds.
The default is 3.