Filter
Top Products
ATA Routing Field Reference
WAN Setup page
ATA Administration Guide 115
A
Router tab > WAN Setup page >
Optional Settings section
HostName The host name of the ATA device.
Domain The network domain of the ATA device.
Primary DNS The DNS server that is used by the ATA device.
NOTE: When DHCP is enabled, you can enter the IP
address of a DNS server in addition to DHCP-supplied
DNS servers. When DHCP is disabled, enter the
primary DNS server. The default is 0.0.0.0.
Secondary DNS Sets the secondary DNS server to take over if
problems are discovered with the Primary DNS server.
NOTE: When DHCP is enabled, you can enter the IP
address of a primary or secondary DNS server in
addition to DHCP-supplied DNS servers. When DHCP is
disabled, enter the primary and secondary DNS server.
The default is 0.0.0.0.
DNS Service Order The method for selecting the DNS server: Manual
(enter the IP address of the DNS server manually; that is
do not look at the DHCP-supplied DNS table), Manual/
DHCP, and DHCP/Manual.
DNS Query Mode The mode of DNS query: parallel or sequential.
NOTE: With parallel DNS query mode, the ATA device
sends the same DNS lookup request to all the DNS
servers at the same time, and the first incoming reply is
accepted by the ATA device.
The default is parallel.
Primary NTP Server The IP address or name of the primary NTP server.
Secondary NTP Server The IP address or name of the secondary NTP server.