Filter
Top Products
ATA Voice Field Reference
Line page
ATA Administration Guide 165
B
Line page
Depending on the ATA device, there may be one or more Line pages (L1, L2, and so
on). You can use the Voice tab > Line page to configure the lines for voice service.
With some variations, depending on the model, his page includes the following
sections:
• ”Line Enable section” section on page166
• ”Streaming Audio Server (SAS) section” section on page166
• ”NAT Settings section” section on page167
• ”Network Settings section” section on page168
• ”SIP Settings section” section on page169
• ”Call Feature Settings section” section on page172
• ”Proxy and Registration section” section on page189
• ”Subscriber Information section” section on page174
• ”Supplementary Service Subscription section” section on page175
• ”Audio Configuration section” section on page178
• ”VoIP Fallback to PSTN section (SPA3102)” section on page179
• ”Gateway Accounts section (SPA3102)” section on page178
• ”Dial Plan section” section on page179
• ”FXS Port Polarity Configuration section” section on page181
In a configuration profile, the Line parameters must be appended with the
appropriate numeral (for example, [1] or [2]) to identify the line to which the setting
applies. The number of lines varies with the model of the ATA device. For example,
the SPA2102 provides two Line tabs (Line 1 and Line 2), while the SPA8000
provides eight tabs (Line1 through Line 8).
More Echo
Suppression
Enable or disable more echo suppresion. The default is no.
This field is not found in the PAP2T.