Filter
Top Products
ATA Voice Field Reference
SIP page
ATA Administration Guide 137
B
Voice tab > SIP page >
Response Status Code Handling section
Reg Retry Long
Intvl
When registration fails with a SIP response code that does
not match
Retry Reg RSC
, the ATA device waits for the specified
length of time before retrying. If this interval is 0, the ATA
device stops trying. This value should be much larger than
the Reg Retry Intvl value, which should not be 0.
The default is 1200.
Reg Retry Random
Delay
Random delay range (in seconds) to add to
Register Retry
Intvl
when retrying REGISTER after a failure.
The default is 0, which disables this feature.
Reg Retry Long
Random Delay
Random delay range (in seconds) to add to
Register Retry
Long Intvl
when retrying REGISTER after a failure.
The default is 0, which disables this feature.
Reg Retry Intvl Cap The maximum value to cap the exponential back-off retry
delay (which starts at
Register Retry Intvl
and doubles on
every REGISTER retry after a failure). In other words, the
retry interval is always at
Register Retry Intvl
seconds after
a failure. If this feature is enabled,
Reg Retry Random Delay
is added on top of the exponential back-off adjusted delay
value.
The default value is 0, which disables the exponential back-
off feature.
SIT1 RSC SIP response status code for the appropriate Special
Information Tone (SIT). For example, if you set the SIT1 RSC
to 404, when the user makes a call and a failure code of
404 is returned, the SIT1 tone is played. Reorder or Busy
tone is played by default for all unsuccessful response
status code for SIT 1 RSC through SIT 4 RSC.
SIT2 RSC SIP response status code to INVITE on which to play the
SIT2 Tone.
SIT3 RSC SIP response status code to INVITE on which to play the
SIT3 Tone.