Filter
Top Products
Basic Administration and Configuration
Setting up Your ATA Device
ATA Administration Guide 37
2
STEP 3 Use the administration computer to install the latest firmware:
a. Extract the Zip file, and then run the executable file to upgrade the firmware.
b. When the
Firmware Upgrade
Warning
window appears, click Continue.
c. In the next window that appears, enter the IP address of the ATA device, and
then click OK.
d. In the
Confirm Upgrade
window, verify that the correct device information and
product number appear. Then click Upgrade.
e. A progress message appears while the upgrade is in progress. The success
window appears when the upgrade is completed. The device reboots.
f. Click OK to close the confirmation message.
g. To verify the upgrade, point the web browser to the IP address of the ATA
device. Check the
Router > Status
page. The
Software Version
field should
show the firmware version that you installed.
NOTE You may need to refresh your browser to display the updated page
reflecting the new version number.
Setting up Your ATA Device
After installation and basic configuration of your ATA device, you will use the
administration web server to finish your configuration.
ATA devices support two levels of administration privileges: Administrator and
User. Both privileges can be password protected.
NOTE By default, there are no passwords assigned for either the Administrator account or
the User account.