Filter
Top Products
ISDN
Program *66-6 – LDN/Trunk Group to Channel Group Assignments
7-34 Strata DK Programming 5/00
Program *66-6 – LDN/Trunk Group to Channel Group
Assignments
Processor Type: DK40i, all RCTUs (Release 4.0 or higher) and BCUs
Program Type: Trunk, PRI and BRI
Initialized Default: Blank
Program *66-6 Overview
This program assigns Listed Directory Numbers (LDNs) trunk groups to the member’s channel
group.
Note The number of direct appearing CO lines cannot exceed the number of CO ports allocated
in Program 03. One PRI card, Type 79, assigns 24 B-channels; thus allowing 24 direct
appearances.
For Programs *66-5 and *66-6:
Multiple calls can be received with the same LDN. The LDN and Channel Group information in
*66-5 and *66-6 must match. Calls are assigned the next available non-busy port as follows:
♦ For PRI: Choose the highest available port to the lowest.
♦ For BRI: Choose the lowest available the highest.
♦ Multiple LDNs can be assigned to the same CO appearances.
Note In Release 4.15, DID/DNIS digits must be registered in this program in order to route
incoming calls on PRI.
✱ ✱ ✱ ✱6SNU✱ +ROG 6SNU +ROG 6SNU +ROG 6SNU +ROG
Channel
Group
Index
CO Line Ports
Channel
Group
Index
CO Line Ports
Channel
Group
Index
CO Line Ports
GRP = Select ISDN trunk ports for each LDN index.
Press 3DJH or 6FUROO for the next CO line ports.
Enter the LDN Index (1~48)
SEL = 6
Enter the Channel Group Number:
0 = BRI; 1~8 = PRI