Filter
Top Products
System & Station
Program *29 – Add-on Modules Button Assignments
3-74 Strata DK Programming 5/00
Program *29 – Add-on Modules Button Assignments
Processor Type: DK14, DK40i, all RCTUs and BCUs
Program Type: Station
Initialized Default: See “Button Assignments” on Page 3-75.
Program *29 Overview
This program allows ADM buttons to be customized. Each ADM button can be programmed as
either a Direct Station Selection, CO line, System Speed Dial or Personal Speed Dial buttons. Only
2000-series Digital Telephones can connect with ADMs, and up to two ADMs can be connected to
a telephone.
✱ ✱ ✱ ✱6SNU✱ +ROG 6SNU +ROG 6SNU +ROG 6SNU +ROG
Processor
Personal Speed
Dial Bin Numbers
System Speed
Dial Bin Numbers
CO Line Range
DSS Button
Range
DK40i
✱10~✱49 ✱60~✱99 001~012 #000~#027
RCTUA
✱10~✱49 ✱60~✱99 001~016 #000~#031
B1CU
✱10~✱49 ✱600~✱699 001~032 #000~#055
RCTUBA/BB
✱10~✱49 ✱600~✱699 001~048 #000~#079
B2CAU/BU
✱10~✱130 ✱600~✱711 001~120 #000~#111
B3CAU/BU
✱10~✱130 ✱600~✱791 001~120 #000~#191
RCTUC/D
✱10~✱49 ✱600~✱699 001~144 #000~#239
RCTUE/F, B5CAU/BU
✱100~✱139 ✱200~✱999 001~200 #000~#335
Port _____ Port _____
Add-on Module 1 Add-on Module 2 Add-on Module 1 Add-on Module 2
Button Code Button Code Button Code Button Code Button Code Button Code Button Code Button Code
10 20 10 20 10 20 10 20
09 19 09 19 09 19 09 19
08 18 08 18 08 18 08 18
07 17 07 17 07 17 07 17
06 16 06 16 06 16 06 16
05 15 05 15 05 15 05 15
04 14 04 14 04 14 04 14
03 13 03 13 03 13 03 13
02 12 02 12 02 12 02 12
01 11 01 11 01 11 01 11
Processor ADMs
Number of
System Speed
Dial Numbers
Number of
Personal Speed
Dial Numbers
DK14 8 40 40
DK40i 12 40 40
RCTUA 12 40 40
RCTUBA/BB, B1CU 40 100 40
RCTUC/D, B2CAU/BU, B3CAU/BU 120 100 40
RCTUE/F, B5CAU/BU 200 800 40
Enter the station logical port of the telephone which
will have buttons assigned to its attached Add-on.
Enter the Add-on Module which will have buttons
assigned to it (0, 1, or 2). Enter 0 when removing
ADMs.
CODE=
See the Code Table below.
LED 01~20
Press the LED that is in the same position as
the Add-on Module button being assigned.