Filter
Top Products
Initialization & Test
Program 90 – Initialize Programs 00~*99
Strata DK Programming 5/00 2-5
Initialization & Test
Program 90 Example
Action LCD Response
1. Use the LCD programming phone per Minimum Hardware
Requirements on Page 1-14.
No. N-N
1
Jan 20 Sun 06:43
1. N-N is the Program Telephone [DN].
2. Enter Program mode by pressing ✱✱✱✱.(Do not press [DN]
button.)
Program Mode
3. 6SNU6SHDNHU+ROG
Access Program 90. System beeps after 6SNU6SHDNHU is pressed
to indicate program number may be entered.
Program = 90
Data Store
4. 6SNU6SHDNHU
Prepare the system for the programs to be initialized.
90 Select =
5. ✱✱+ LED buttons 01 & 02
Enter Program numbers individually, followed by #, or in a range. For a
range, separate the low program number and the high program
number with an asterisk.
✱✱ initializes all Programs 00~
99.
Star ✱ Program memory follows Program 97.
90 Select = 00**99
Data Clr
6. +ROG
Secure data in system programming. LEDs 01 and 02 flash.
90 Select = 00**99
Data Programmed
7. 6SNU6SHDNHU
Prepare system for another selection (go back to Step 5) or exit
Program 90 (continue with Step 8).
90 Select =
8. +ROG
Secure default data in system memory. LED 01 and 02 continue to
flash.
90 Select = ##
Data Programmed
9. 6SNU6SHDNHU
Exit Program 90. Enter another program number (see “Program 92
Example” on Page 2-10) or exit programming mode (go to Step 10).
System beeps to indicate it is exiting Program 90.
Program =
10. +ROG
Exit programming mode.
The system will not allow the 6SNU6SHDNHU LED to light to re-
enter the programming mode.
No. N-N
Jan 20 Sun 06:43