Filter
Top Products
5.17
FAX
5
Receiving Automatically in ANS/
FAX Mode
For this mode, you must attach an answering machine to the
EXT jack on the back of your product (see
page 1.9
).
1
Press
Receive Mode
on the front panel repeatedly
until you see “ANS/FAX”. Then, press
Enter
.
2
When you receive a call, the answering machine will
answer.
If the caller leaves a message, the answering machine
stores the message as it would normally. If your product
hears a fax tone on the line, it automatically starts to
receive the fax.
NOTES:
• If you have set your product to ANS/FAX mode and your
answering machine is switched off, or no answering machine
is connected to your product, your product will automatically
go into FAX mode after predefined rings. The ring count may
vary depending on your country.
• If your answering machine has a ‘user-selectable ring
counter’, set the product to answer incoming calls within 1
ring.
• If you are in TEL mode (manual reception) when the
answering machine is connected to your product, you must
switch off the answering machine, or the outgoing message
from the answering machine will interrupt your phone
conversation.