Samsung SF-430 Cordless Telephone User Manual


 
7.14
TROUBLESHOOTING
Part of the
printed page is
blank.
The page layout is too complex. Simplify the page layout
and remove any unnecessary graphics from the
document if possible.
The page orientation setting may be incorrect. Change
the page orientation in the Printer Properties dialogue
box.
The paper size and the software paper size settings do
not match. Insert the correct paper into the product or
change the software paper size settings.
If using a parallel cable, ensure that it is compliant with
an IEEE-1284 rated cable.
Your product
prints the wrong
data, or it prints
incorrect
characters.
The printer cable might not be connected properly.
Check the printer cable connection.
There may be a problem with the printer driver software.
Exit Windows and reboot the computer. Turn the printer
off and then back on again.
If using a parallel cable, ensure that it is compliant with
an IEEE-1284 rated cable.
Printing is too
slow.
You may be using High or Maximum print quality. See
page 2.11. The higher the quality, the lower the speed.
If you are using Windows NT, the Scheduling setting may
be set incorrectly. From the Start
menu, select Settings
and Printers. Click your printer icon with the right
mouse button, select Properties, click the Scheduling
tab. Then, select the desired scheduling setting from the
available choices.
When printing
using the USB
connection, an
error occurs
repeatedly
When the USB mode is set to FAST, the communication
between the product and the computer may be poor.
Change the USB mode to SLOW. To do so, take the
following steps:
1. Press
Setup
on the front panel. You can see “1.SYSTEM
SETUP” on the display.
2. Press
Enter
.
3.
Press the
Scroll
buttons ( or ) until you see
“USB MODE” and then press
Enter
.
4. Press
the
Scroll
buttons ( or ) to select “SLOW”
and then press
Enter
to save the selection.
Problem Possible Cause and Remedy