Filter
Top Products
4.4 COMMON DIGITAL INTEGRATION FEATURES AND SETUP PROCEDURES
86
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX
1.
Enter Station Programming:
For KX-TA624
With the phone on-hook,
Set
the
MEMORY
switch to
"PROGRAM"
.
(Display changes to PITS-PGM Mode.)
For KX-TD series
Enter PITS programming:
a. With the phone on-hook,
Press
the
PROGRAM
button.
b. Dial [
99
]. (Display changes to PT-PGM Mode.)
2.
Press
the code for the mode you want this phone to have.
Hands-Free = #11(for KX-TA624) or 71 (for KX-TD series)
Private = #12 (for KX-TA624) or 72 (for KX-TD series)
Screen output: Hands-Free or Private
3.
Press STORE.
4.
Exit the program mode:
For KX-TA624
Set
the
MEMORY
switch to
"SET"
.
For KX-TD series
Press
the
PROGRAM
button or lift the handset.
5.
Repeat these steps at each telephone.
For the KX-TD series only:
A single-line telephone that is connected to the same extension as a proprietary telephone can
also be used to monitor an incoming message. Be sure that Live Call Screening on the
connected proprietary telephone has been activated. This feature is useful when you are using
a cordless telephone. The handset sounds an alert tone to let you know that a message is being
recorded. To intercept the call, flash the hook.
4.4.4 Live Call Screening Button Assignment
For the Live Call Screening feature to work at an extension, the extension must have an LCS
button on it and the button must be lit at the time of the message. This key must be either a
DSS/BLF or CO key (must have a lamp). Follow the procedure below to assign an LCS button
on an extension. (This is a station level program and should be done at each individual phone.)
1.
Enter Station Programming:
For KX-TA624
With the phone on-hook,
Set
the
MEMORY
switch to
"PROGRAM"
.
(Display changes to PITS-PGM Mode.)
For KX-TD series
a. With the phone on-hook,
Press
the
PROGRAM
button.
b. Dial [
99
]. (Display changes to PT-PGM Mode.)
2.
Press
the desired
FLEXIBLE
(
CO
or
DSS/BLF
) button you want to assign as the LCS
button.
Conditions: None