Filter
Top Products
7.2 UTILITY COMMANDS
SYSTEM MAINTENANCE AND TROUBLESHOOTING
137
printer or data terminal must be connected to the VPS at the RS-232C port for the reports to be
printed or displayed.
1.
Type PSET
, then
Press RETURN.
2.
Type [1]
to enable this function or
Type [2]
to disable it.
3.
Type
the time to print the reports.
Note
The reports will be displayed only if the system is in the mode where the ">" prompt
is displayed
.
7.2.6 Error Log Display (ELOG)
This command is used when diagnosing VPS problems. When selected, this command will
display an error log.
Type ELOG
, then
Press RETURN.
Note
The errors that can be identified by the system are displayed and explained in the following
tables.
$ PSET
Report Print Out Service [ Disable ]
1 : Enable 2: Disable :=
Enter The Print Out Time (HH:MM, AM/PM) :=
COM. Communication error between CPU and DSP
DATA Process error of voice data
MEM. Memory error
PRG. Program error in CPU card
R/W Read/Write error of Flash Memory
$ ELOG
DEVICE ERROR TIME
JUL-14 14:00 PMMEM-GET1. CPU
JUL-14 14:00 PM2. CLOCK
JUL-14 14:00 PMDATA R/W (xx:yyyy)3. FLASH
MEMORY
JUL-14 14:00 PMSCAN4. DSP*
JUL-14 14:00 PMFIFO5. DSP*
JUL-14 14:00 PMAPPLICATION (x)6. CPU
* = Port number (1-2)