Filter
Top Products
B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGS
252
SYSTEM ADMINISTRATOR'S GUIDE
Inband Signaling Parameters
These parameters are used if the PBX sends DTMF tones to the VPS to indicate the state of a
call (busy, answered, disconnected, etc.). The integration Mode must be set to "Inband." If PBX
type is set to a KX-T series telephone system, the Inband Signaling parameters will
automatically default to the proper codes.
The following parameters can be programmed using "0-9", " ", "#", and "A-D."
Call Waiting
Sequence
(1)
This sequence is carried out by the VPS when performing
call waiting if the extension being called is busy.
Release
Sequence for
Call Waiting
(F)
This sequence is performed by the VPS to release call
waiting.
To select Inband Signaling Parameters, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 3 - 2
Table 69
Parameter Value Range
(Default)
Description/Function
Ringback
(1)
Indicates "Ringback Tone." Sent to the VPS when the
extension dialed is ringing.
Busy
(2)
Indicates "Busy Tone." Sent to the VPS when the
extension dialed is busy.
Reorder
(3)
Indicates "Reorder Tone." Sent to the VPS when an
invalid extension number is dialed or when inadvertently
connected to another VPS.
DND
(4)
Indicates "Do Not Disturb Tone." Sent to the VPS if the
dialed extension has the Do Not Disturb feature enabled.
Answer
(5)
Sent to the VPS when the called extension answers the
call.
Forward to VM
Ringing (6)
Sent to the VPS if the called extension is forwarded to a
voice mail port and that voice mail port is available to
accept the call.
Table 68
Parameter Value Range
(Default)
Description/Function