Panasonic KX-TVS80 Telephone User Manual


 
4.3 CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD308
INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX
83
Screen output:
This message is shown when the digital (DPT) connection between the VPS and
telephone system cannot be established. This is normal. This message appears because
the PBX type for the VPS is not a KX-TD series system. Since the default PBX type is
set to the KX-TA series at the factory, this message will always appear. To change the
default, go to the
System Administration Top Menu
, and Type 1-6-3-1. (Program -
Hardware Settings - PBX Interface Parameters - Dialing Parameters Menu). Select
"2:KXT Series" at the "1. PBX Type", and select "4:DPT" at the "2. Integration Mode".
Exit the menu by entering "\", and the following display will be shown.
Screen output:
If "DPT Interface Connection is not Established" is still shown, possible causes
are:
10.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b) "**ON LINE MODE**"
is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration,
Press
ENTER
. All parameters can be set through the menu-driven program.
11.
Go to the
System Administration Top Menu.
Type
[5]
and
Press ENTER
, or Type
[3]
then
QSET
and
Press ENTER
for Quick Setup and follow the Auto Configuration Instructions.
Table 17
Cause Action
The cabling between the PBX
extension ports and the VPS is not 4-
wire or is improperly connected.
Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
The PBX is a KX-TD series but does
not have the proper level of software
required to support DPT Integration.
Contact National Parts Center
at 1-800-833-9626
or use Inband Integration under
hardware settings.
The PBX is not programmed properly
to support DPT Integration.
Do required integration
programming as described in
this chapter.
Active COs: 1 2
APT Interface Connection is not Established
** OFF LINE MODE **
** OFF LINE MODE **