Filter
Top Products
B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
238
SYSTEM ADMINISTRATOR'S GUIDE
Other Parameters - External Message Delivery
Used to control the handling of External Message Delivery calls.
Message
Waiting Lamp
Ports
Port No.
(1, 2)
Specifies the port numbers used for the Message Waiting
Notification Lamp feature.
The VPS turns on the Message Waiting Lamp of the
extension using the port specified in this field. At least 1
port must be specified.
Message
Waiting Lamp
for Every
Message
1. No
2. Yes
(Yes)
When set to "Yes," the VPS will turn on the Message
Waiting Lamp of the extension each time a new message
is recorded in the mailbox. This will occur even if the
Message Waiting Lamp was not turned off from a
previous message. This setting is useful when the first
attempt is unsuccessful.
When set to "No," the VPS will turn on the Message
Waiting Lamp for the first message only. The VPS will
not turn on the lamp for subsequent messages until the
Subscriber has accessed the VPS to retrieve the messages
stored there.
Max. Digits for
Callback No.
1-48 digits
(20)
Specifies the maximum number of digits the caller can
enter as a callback number. This number will be
displayed on beepers if the "Beeper Callback No. Entry
Mode" is enabled.
Callback No.
Entry Interdigit
Time- Ou t
1-10 s
(5)
Sets the maximum allowable time between each digit on
Beeper Callback No. Entry. If the caller does not enter
any digits within the specified time, the VPS will not
accept entry of any additional digits.
System
Callback No.
Up to 32 digits
(None)
Specifies a telephone number displayed on the
Subscriber's beeper as a callback number when "Type" is
set to "Beeper."
Note
: If "Beeper Callback No. Entry Mode" is enabled
through COS, the callback number entered by the caller
will be displayed on the destination beeper instead of the
System Callback No. However, if the caller fails to enter
a callback number, the System Callback No. will be
displayed.
Table 56
Parameter Value Range
(Default)
Description/Function