Filter
Top Products
5.2 PORT SETTING OPTIONS
104
CUSTOMIZING THE SYSTEM
Example for KX-TA624: All sales telephones have been placed in extension group 3 in
system program [600]. Station Hunting feature is disabled in [100]. Assign each
salesperson's mailbox to a different COS in the KX-TVS50/80 and assign the paging group
to that COS. (This tells the VPS which paging group to dial). In the Intercom paging section,
assign the number "333" to the paging group assigned to the sales dept.
Fax Management (1 - 5 - 7 - 8)
Assigns up to 2 fax machines that can be extensions from the PBX. If the CNG tone is heard,
the KX-TVS50/80 will automatically forward the call to the first fax machine. If the first fax
machine is busy or doesn't answer (is out of paper), the call is forwarded to the second fax
machine. Also allows assigning an extension as the fax manager to be notified on incoming
faxes.
Disconnect Parameter (1 - 5 - 7 - 9)
Determines how many seconds of silence the KX-TVS50/80 allows during a caller's message
before disconnecting the call.
RS-232C Settings (1 - 6 - 1)
Allows the system administrator to change the baud, bit, etc.
Port Setting (1 - 6 - 2)
Only to be used if bringing actual CO lines into the VPS. Use the CPC control of the telephone
switch for normal disconnect problems.
Dialing Parameters (1 - 6 - 3 - 1)
These parameters are set automatically when Quick Setup is conducted.
Most of the settings will be left alone. The one setting that is changed quite often is the Transfer
Sequence for the operator or the extension. By default it is set at FX on APT/DPT Integration
and FTX for Inband Integration. In other words, the voice processor dials the flash, waits for
intercom tone and dials the extension number. By default the KX-TVS50/80 will stay on the
line to monitor the status of the call. If the extension user answers the voice processor will
announce "
you have a call
" prior to releasing the call. This can be alleviated by adding the letter
"A" or "D" to the sequence. "A" stands for answer; the call will be transferred without the
"you
have a call"
For a blind or unscreened transfer, add the letter "D" for disconnect.