Filter
Top Products
188
Configure the new unit’s properties using the General tab. Configure the new unit’s IP and serial port settings using
the Comm tab. For more information on configuring unit properties, see Unit Properties.
Press OK to add the unit to the site or Cancel to return to Console. The added unit appears on the Site View tab of
the Site pane, highlighted in orange as shown below:
NOTE: The Status bar at the bottom of the Console window displays the current status of the
unit and the site. As shown above, site data errors and unit data errors are indicated by
magenta and red LEDs respectively. Complete unit configuration with correct settings to
clear the errors. When correct configuration is complete, the status LEDs will change to
green. The Status bar also displays Last Macro and Last Preset.