Filter
Top Products
Connecting Paging, Call Reporting (SMDR),
and Music-on-Hold Devices
PAGE Jack
SMDR Jack
Jack
AT&T 572
Serial Printer
(optional)
Volume Control
Paging System (optional)
MUSIC ON HOLD
Audio Source
(optional)
Paging System:
To install an AT&T
paging system, insert the modular plug
for the paging system into the jack
labeled PAGE on the primary processor
module. Route the cord as for line and
extension cords, then connect it to the
loudspeaker paging system.
Call Reporting (SMDR) Printer: To
install an AT&T 572 Serial Printer for call
reporting, insert one end a D8W
modular cord into the jack labeled
SMDR on the primary processor
module. Plug the other end into an
AT&T 355AF adapter and then plug the
355AF adapter into the RS-232 serial
port on the printer.
Music-on-Hold Audio Source: A) To B) To adjust volume, first use a
connect an audio source, insert an RCA
flathead screwdriver to turn the volume
plug into the jack labeled MUSIC ON
control on the primary processor
HOLD on the primary processor
module counter-clockwise to the lowest
module. Route the cord as you did for
setting, then connect the AC power.
the line and extension cords, then
Place a call on hold and listen while
connect it to the audio source.
adjusting volume. If you do not hear
music at any setting, check System
Programming procedure #602 (see
page 5-13).
NOTE: Only the steps for connection to the equipment controller are provided
here. See Chapter 5 for instructions on activating the Music-on-Hold Jack,
Chapter 6 for using the paging system, and Chapter 7 for information on call
reporting. Also refer to the manufacturer’s instructions for additional information on
using these devices.
Installing the Hardware
2-13