Filter
Top Products
Chapter 5 Broadband
EMG5324-D10A User’s Guide
88
5.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode.
Figure 17 Broadband Add/Edit: Bridge
The following table describes the fields in this screen.
IPv6
Address
Enter the static IPv6 address provided by your ISP using colon (:) hexadecimal notation.
IPv6 DNS
Server
Select whether you want to obtain the IPv6 DNS server addresses automatically or
configure them manually.
Obtain IPv6
DNS info
Automatically
Select this to have the Device get the IPv6 DNS server addresses from the ISP
automatically.
Use the
following Static
DNS IPv6
Address
Select this to have the Device use the DNS server addresses you configure manually.
Primary
IPv6 DNS
Server
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary
IPv6 DNS
Server
Enter the second IPv6 DNS server address assigned by the ISP.
Apply Click Apply to save your changes.
Back Click Back to return to the previous screen.
Table 6 Broadband Add/Edit: Routing (continued)
LABEL DESCRIPTION
Table 7 Broadband Add/Edit: Bridge
LABEL DESCRIPTION
General
Name Enter a service name of the connection.
Type The Device transmits data over the Ethernet WAN port.
Mode Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
VLAN