ZyXEL Communications EMG5324-D10A IP Phone User Manual


 
Chapter 1 Introduction
EMG5324-D10A User’s Guide
21
Refer to the Quick Start Guide for information on hardware connections.
PHONE1-2 Green On A SIP account is registered for the phone port.
Blinking A telephone connected to the phone port has its receiver off of
the hook or there is an incoming call.
Orange On A SIP account is registered for the phone port and there is a
voice message in the corresponding SIP account.
Blinking A telephone connected to the phone port has its receiver off of
the hook and there is a voice message in the corresponding SIP
account.
Off The phone port does not have a SIP account registered.
INTERNET Green On The Device has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a
DHCP server), PPP negotiation was successfully completed (if
used).
Blinking The Device is sending or receiving IP traffic.
Off The Device does not have an IP connection.
Red On The Device attempted to make an IP connection but failed.
Possible causes are no response from a DHCP server, no PPPoE
response, PPPoE authentication failed.
WAN Green On This light applies when the Device is in Ethernet WAN mode. The
Device has an Ethernet connection with a device on the WAN.
Blinking The Device is sending or receiving data to/from the Ethernet
WAN.
Off The Device does not have an Ethernet connection with the WAN.
ETHERNET1-4 Green
(Giga
Ethernet)
On The Device has a successful 1000 Mbps Ethernet connection with
a device on the Local Area Network (LAN).
Blinking The Device is sending or receiving data to/from the LAN at 1000
Mbps.
Orange
(Fast
Ethernet)
On The Device has a successful 10/100 Mbps Ethernet connection
with a device on the Local Area Network (LAN).
Blinking The Device is sending or receiving data to/from the LAN at 10/
100 Mbps.
Off The Device does not have an Ethernet connection with the LAN.
POWER Green On The Device is receiving power and ready for use.
Blinking The Device is self-testing.
Red On The Device detected an error while self-testing, or there is a
device malfunction.
Off The Device is not receiving power.
WLAN/WPS Green On The wireless network is activated and is operating in IEEE 802.11
“b”, “g” or “n” mode.
Blinking The Device is communicating with other wireless clients.
Orange On The WPS is configured.
Blinking The Device is setting up a WPS connection.
Off The wireless network is not activated.
Table 1 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION