Filter
Top Products
Chapter 17 VPN
EMG5324-D10A User’s Guide
203
The Secure Gateway IP Address may be configured as 0.0.0.0 only when using IKE key
management and not Manual key management.
Finding Out More
See Section 17.6 on page 210 for advanced technical information on IPSec VPN.
17.1.3 Before You Begin
If a VPN tunnel uses Telnet, FTP, WWW, then you should configure remote management (Remote
MGMT) to allow access for that service.
17.2 VPN Setup Screen
The following figure helps explain the main fields in the web configurator.
Figure 105 IPSec Summary Fields
Local and remote IP addresses must be static.
Click Security > VPN to open the VPN Setup screen. This is a menu of your IPSec rules (tunnels).
The IPSec summary menu is read-only. Edit a VPN by selecting an index number and then
configuring its associated submenus.
Figure 106 Security > VPN > Setup
Local Network
Local IP Address
My IP Address
Secure Gateway IP Address
Remote Network
Remote IP Address
Remote
IPSec Router
VPN Tunnel