Filter
Top Products
Chapter 9 Quality of Service (QoS)
EMG5324-D10A User’s Guide
156
Class Name Enter a descriptive name of up to 32 printable English keyboard characters, including
spaces.
Classification
Order
Select an existing number for where you want to put this classifier to move the classifier to
the number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
Forward to
Interface
Select a WAN interface through which traffic of this class will be forwarded out. If you select
Unchange, the Device forward traffic of this class according to the default routing table.
DSCP Mark This field is available only when you select the Ether Type check box in Criteria
Configuration-Basic section.
If you select Mark, enter a DSCP value with which the Device replaces the DSCP field in the
packets.
If you select Unchange, the Device keep the DSCP field in the packets.
802.1p Mark Select a priority level with which the Device replaces the IEEE 802.1p priority field in the
packets.
If you select Unchange, the Device keep the 802.1p priority field in the packets.
VLAN ID If you select Remark, enter a VLAN ID number (between 1 and 4095) with which the
Device replaces the VLAN ID of the frames.
If you select Remove, the Device deletes the VLAN ID of the frames before forwarding
them out.
If you select Add, the Device treat all matched traffic untagged and add a second VLAN ID.
If you select Unchange, the Device keep the VLAN ID in the packets.
To Queue Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface Select whether the traffic class comes from the LAN or a wireless interface.
Ether Type Select a predefined application to configure a class for the matched traffic.
If you select IP, you need to configure source or destination MAC address, IP address, DHCP
options, DSCP value or the protocol type.
If you select IPv6, you need to configure the source or destination IPv6 addres and prefix
length.
If you select ARP, you need to configure the source’s MAC address and MAC Mask.
If you select 8021Q, you can configure an 802.1p priority level and VLAN ID in the Others
section.
Source
MAC
Address
Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet’s MAC
address should match.
Enter “f” for each bit of the specified source MAC address that the traffic’s MAC address
should match. Enter “0“ for the bit(s) of the matched traffic’s MAC address, which can be of
any hexadecimal character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of
00:13:49:12:34:56 matches this criteria.
Table 37 Class Setup: Add/Edit (continued)
LABEL DESCRIPTION