Filter
Top Products
Chapter 1 Introduction
EMG5324-D10A User’s Guide
19
Turn the Wireless LAN On or Off
1 Make sure the POWER LED is on (not blinking).
2 Press the WLAN ON/OFF button for one second and release it. The WLAN/WPS LED should change
from on to off or vice versa.
Activate WPS
1 Make sure the POWER LED is on (not blinking).
2 Press the WLAN ON/OFF button for more than five seconds and release it. Press the WPS button on
another WPS -enabled device within range of the Device. The WLAN/WPS LED should flash while
the Device sets up a WPS connection with the wireless device.
Note: You must activate WPS in the Device and in another wireless device within two
minutes of each other. See Chapter 6 on page 113 for more information.