ZyXEL Communications EMG5324-D10A IP Phone User Manual


 
Chapter 5 Broadband
EMG5324-D10A User’s Guide
84
Prefix Delegation
Prefix delegation enables an IPv6 router to use the IPv6 prefix (network address) received from the
ISP (or a connected uplink router) for its LAN. The Device uses the received IPv6 prefix (for
example, 2001:db2::/48) to generate its LAN IP address. Through sending Router Advertisements
(RAs) regularly by multicast, the Device passes the IPv6 prefix information to LAN hosts. The hosts
use the prefix to generate their IPv6 addresses.
5.1.3 Before You Begin
You need to know your Internet access settings such as encapsulation and WAN IP address. Get this
information from your ISP.
5.2 The Broadband Screen
The Device must have a WAN interface to allow users to use the Ethernet WAN port or DSL port to
access the Internet. Use the Broadband screen to view or modify a WAN interface.
Click Network Setting > Broadband. The following screen opens.
Figure 15 Network Setting > Broadband
The following table describes the fields in this screen.
Table 5 Network Setting > Broadband
LABEL DESCRIPTION
Add new WAN
Interface
Click this to create a new WAN interface.
# This is the index number of the connection.
Name This is the service name of the connection.
Type This shows the type of interface used by this connection.
Mode This shows whether the connection is in routing mode or bridge mode.
Encapsulation This shows the method of encapsulation used by this connection.
IPv6/IPv4 Mode This shows whether the connection uses IPv6 or IPv4.
VPI This is the Virtual Path Identifier (VPI).
VCI This is the Virtual Channel Identifier (VCI).
Vlan8021p This indicates the 802.1P priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
VlanMuxId This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
ATM QoS This shows the ATM Quality of Service (QoS) type configured for this connection. This
displays N/A when there is no ATM QoS assigned.