Filter
Top Products
Chapter 8 Routing
EMG5324-D10A User’s Guide
146
8.2 Configuring Static Route
Use this screen to view and configure IP static routes on the Device. Click Network Setting >
Static Route to open the following screen.
Figure 63 Network Setting > Static Route
The following table describes the labels in this screen.
Table 31 Network Setting > Static Route
LABEL DESCRIPTION
Add New Static
Route
Click this to set up a new static route on the Device.
# This is the number of an individual static route.
Active This indicates whether the rule is active or not.
A yellow bulb signifies that this static route is active. A gray bulb signifies that this static
route is not active.
Status This shows whether the static route is currently in use or not. A yellow bulb signifies that
this static route is in use. A gray bulb signifies that this static route is not in use.
Name This is the name that describes or identifies this route.
Destination IP This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Modify Click the Edit icon to go to the screen where you can set up a static route on the Device.
Click the Delete icon to remove a static route from the Device.