Filter
Top Products
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– Step 4: Install DKAdmin
11
Installing DKAdmin
Notes
● If you installed DKAdmin for the first time, a 280ADMIN directory was created and the
DKAdmin files copied to it.
● If you upgraded an existing DKAdmin program, your customer database has been
maintained in the 280ADMIN directory.
DOS Only PC from CD-ROM
In the rare case your DOS only PC has a CD-ROM, follow these steps:
1. Insert the CD-ROM into your CD-ROM drive. Change the DOS prompt to that drive and
type: cd\dkados and press Enter.
Type: install and press Enter.
2. Go to Step 3 of the procedure entitled “DOS Only PC from Floppy Disks” below.
Disregard procedures refering to Disk #2.
CAUTION! During installation, selecting “New Installation” overwrites the existing
DKAdmin customer list if you already have DKAdmin or 280Admin installed on your PC.
Although the customer list is overwritten, you can still retrieve the existing customer data
associated to that name by adding that customer’s name using the “Maintain Customer”
selection on the newly installed DKAdmin. Do this for each customer name that is overwritten
on the list.
DOS Only PC from Floppy Disks
1. Insert the DKAdmin Disk #1 into drive A: (or B:).
2. Using DOS, type: a:\install (or b:\install) at the C: prompt and press Enter.
The Toshiba Install DKAdmin System screen automatically displays. Follow the prompts
to install DKAdmin.
3. During installation, if you have an existing customer file in an older version of DKAdmin
(280Admin) on your PC, highlight the DKAdmin 4.0 Upgrade Installation
Only selection and press Enter.
...or if you are installing for the first time, highlight the DKAdmin 4.0 New
Installation selection and press Enter.
CAUTION! During installation, selecting “New Installation” overwrites the existing
DKAdmin customer list if you already have DKAdmin or 280Admin installed on your PC.
Although the customer list is overwritten, you can still retrieve the existing customer data
associated to that name by adding that customer’s name using the “Maintain Customer”
selection on the newly installed DKAdmin. Do this for each customer name that is overwritten
on the list.
4. Remove the floppy disk from your floppy disk drive and reset the PC to initialize the
changes made during installation.
5. Go to Step 3 in the “Run DKAdmin Program” on Page 12.
Notes
● If you installed DKAdmin for the first time, a 280ADMIN directory was created and the
DKAdmin files copied to it.