Filter
Top Products
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– Restore Data
103
Backup Menu (DKBackup)
Notes
● When you back up PRGALL, the DK security code, set in the DKBackup customer
database, is not sent to the processor. You must always enter the DK security code that is
actually programmed on the processor installed in the Strata DK. You can change the DK
security code using the DKAdmin Program Administration Section option or manually
using the programming telephone.
● Access to the DK Code should be considered highly confidential and only given to those
individuals with the security level which enables them to program or update DK data. If
changing the Strata DK Program 00 Passwords, always change both Level 1 and 2 for
security. DKAdmin/DKBackup checks both codes and run with either code.
● After you enter the DK Code, the computer will display the DK System Program File list
is displayed (see screen in Step 3 below). If this screen does not display, the DKAdmin/
DKBackup PC and the Strata DK are not communicating. See Appendix A – Connecting
to Strata DK to verify that the PC COM port is connected to the Strata DK PIOU, RSSU,
RSIS, RSIU or PIOUS TTY port, or IMDU or RMDS modems.
● Make sure the programming telephone (station 205 or 213) is not in the programming
mode if communications are not established.
3. After entering the DK code, the following screen displays.
Note If the PC and Strata DK do not communicate, the Problem: Unable to Establish
Communications screen appears. Follow the instructions on the screen and/or see
Appendix A – Connecting to Strata DK to correct the problem.
4. Highlight the program file you wish to restore and press the spacebar to tag (checkmark)
the program file. Repeat this step for as many program files as you wish to restore. Press
F2 to tag all files.
CAUTION! Do not restore the PRGALL file while the system is in use. Restoring the file,
interrupts service by blanking out [DNs] temporarily.
5. After selecting the files, press F4. The pop-up window shown below displays. If you are
changing ROMs/Flash Memory or PCBs, follow the instructions on the screens to add or
change PCBs and reset the Strata DK communications port.
If you are changing from a PIOU/PIOUS/RSSU to a RSIU or RSIS, you are able to
increase the DKAdmin/DKBackup PC COM port baud rate (for example, from 1200 to
9600).
DK System Program File
PRGALL All System Programs
REPALL All Station and System Speed Dial Numbers
NAMEALL All User Names
VIDALL All Voice Mail ID Codes (#656)
MIDALL All Voice Mail Message Waiting Codes (#657)
ADMEMOAL All Station and System Speed Dial Memos
MSGALL All Station and System LCD Messages
CFAALL Directory Number Call Forwarding settings (R3)
MWALL All Message Waiting Settings (R3)
CLID All Class/ANI Lost Call Number Storage Data (R3)