Filter
Top Products
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––– Restore Data
105
Backup Menu (DKBackup)
7. After completing the steps on the screen, press Enter (twice) and the Baud Rate
Selection screen displays (shown below). This screen enables you to set the DKAdmin/
DKBackup PC COM port baud rate which must match the baud rate of the TTY or modem
port set by the programming telephone.
8. Select the DKAdmin/DKBackup PC COM port baud rate and press Enter. The
information screen below instructs you to pull Program 03 if you changed any PCBs
during the Restore process. DKAdmin/DKBackup enables you to pull Program 03
automatically.
Note If you are connected to the customer system, always have DKAdmin/DKBackup pull
Program 03 when restoring data. If you are restoring data to an RCTU that is installed
in a test system that is not loaded with the same PCBs as the customer database, do not
pull Program 03 at this time.
DKAdmin/DKBackup will then download Program 03 and Program 76 to ensure a
successful restore process.
Baud Rate Selection
Please adjust the baud rate of DKBackup PC COM port to match the new
PIOU, PIOUS, RSSU or RSIU/RSIS you may have installed.
Baud Rate ...............
9600
Processor Conversion
If you added or changed any PCBs other than the RCTU PCB in the DK system,
the customer database will need to be updated to reflect these changes.
You can pull Program 03 from the DK to accomplish this.
If you pull Program 03 from the DK, you will override the existing
customer database with the DK data.
If you do not pull Program 03 from the DK, the existing customer database
will remain intact.
IMPORTANT: If you have upgraded the customer database offline, DO NOT pull
Program 03 as it will override your changes.
IMPORTANT: Any time DK14/DK16e/DK40 is upgraded, Program 03 must be
pulled so DKAdmin can update the new system’s cabinet drawing.
NOTE: If you pull Program 03 from the DK, the DK will be initialized with
Program 91-1 automatically. This initialization program identifies the
PCBs to the DK.
Press any key to Continue
300
1200
2400
4800
9600
14400
19200
38400
57600