Filter
Top Products
Configuring Communication
46
NXD-700Vi 7" Modero® Wall/Flush Mount Touch Panel with Intercom
Step 2: Configure the Card’s Wireless Security Settings
The second step to successfully setting up your wireless card is to configure the Wireless Settings section of
the Wireless Settings page. This section configures both the communication and security parameters from the
internal wireless card to the WAP. The procedures outlined within the following sections use an 802.11g card
to configure a common security configuration to a target WAP.
Refer to either the Wireless Settings Page section on page 88 or the Appendix B - Wireless Technology section
on page 197 for more information on the other security methods.
Once you have set up the wireless card parameters, you must configure the communication parameters for the
target Master; see Step 3: Choose a Master Connection Mode section on page 52.
Configuring the Modero’s wireless card for unsecured access to a WAP200G
In the Protected Setup page:
1. Press the Wireless Settings button (located on the lower-left) to open the Wireless Settings page.
2. Enter the SSID information by either:
Automatically having it filled in by pressing the Site Survey button and from the Site Survey page,
choosing an Open WAP from within the Site Survey page and then pressing the Connect button.
Manually entering the SSID information into their appropriate fields by following steps 7
thru 9.
FIG. 28 Wireless Settings page (showing a sample unsecured configuration)
FIG. 29 Site Survey of available WAPS (Unsecured WAP shown selected)
Panel
connection
IP info.
Wireless
card security settings
Select an OPEN
(unsecured) WAP
Connecting to the
WAP begins the
communication