Filter
Top Products
NXA-AVB/ETHERNET Breakout Box
9
NXD-700Vi 7" Modero® Wall/Flush Mount Touch Panel with Intercom
NXA-AVB/ETHERNET Breakout Box
The NXA-AVB/ETHERNET Breakout Box (FIG. 5) is included as part of the NXD-700Vi Kit configuration
(panel and box) but can be purchased as a separate accessory. This box facilitates the installation and
distribution of video, data, and audio to Modero touch panels located up to 200 feet (60.96 m) from the AVB
box. This unit accepts either Composite or S-Video from standard video devices.
This breakout box can be mounted on either a horizontal flat surface or within an equipment rack
(by using an optional AC-RK Rack Kit).
Product Specifications
FIG. 5 NXA-AVB/ETHERNET Breakout Box (front and rear views)
NXA-AVB/ETHERNET Product Specifications
Dimensions (HWD): • 1.50" x 5.55" x 4.88" (3.81 cm x 14.10 cm x 12.40 cm)
• Width when attached to mounting ears: 6.65" (16.89 cm)
Power Consumption: • 50mA (with audio/video input)
• 23mA (with no audio/video)
• Routed through NXA-AVB/Ethernet using a 12 VDC-compliant power supply
Certifications: • FCC Part 15 Class B, CE, and EN60950
Features: • Accepts either Composite or S-Video (video-capable panels only)
• Provides audio distribution to the non-video touch panels over a CAT5 cable
(up to 200 ft.)
• Provides video/audio distribution to the video-capable touch panels over
CAT5 cable up to 200 ft.(60.9 m)
Availability: • This unit is included with CV5, CV7, CV10, NXD-700Vi, NXD-1000V,i and
1200V-Series Kit configurations
Front Components: • 2-pin 3.5 mm Phoenix connector for power to the touch panel
• Green LED provides an indication of power status
• RJ-45 connector provides Ethernet signals to the touch panel
• RJ-45 connector provides differential audio and video signals to the touch
panel (panel type dependant)
Rear Components: • 6-pin 3.5 mm Phoenix connector for in-bound (left/right channel) audio
• 4-pin 3.5 mm Phoenix connector for out-bound (from microphone) audio
• BNC connector (female) for Composite or Chroma (for video-capable
panels only)
• BNC connector (female) for luminance (for video-capable panels only)
• RJ-45 connector for Ethernet input from the control system
• 2-pin 3.5 mm Phoenix connector for in-bound power
Power In
(front)
Ethernet (to panel)
Audio/Video
Power (to panel)
S-Video Chroma
Composite/
Mic Out
Audio
In
Ethernet In
S-Video
Luma
(rear)
(to panel)