Filter
Top Products
Installation and Upgrade of the Internal NXD Components
23
NXD-700Vi 7" Modero® Wall/Flush Mount Touch Panel with Intercom
6. To complete the upgrade process, either upgrade the remaining wireless card (Step 3) or close and re-
secure the enclosure using the procedures in Step 3: Close and Re-secure the NXD Panel
Enclosure section on page 23.
Step 3: Close and Re-secure the NXD Panel Enclosure
1. Gently place the outer housing back onto the panel and align the four pan-head Housing Screws holes
along the edges of the outer housing.
2. Insert and secure the four pan-head Housing Screws back into their pre-drilled holes by using a grounded
Phillips-head screwdriver.
3. Slip the connector overlay back into the connector opening by inserting the top of the overlay into the
connector opening in an upwards direction.
4. Align the connectors to their respective locations and secure the overlay by pushing it towards the
connectors until the overlay securely snaps back into the overlay release latches.
5. Re-install the faceplate back onto the panel. Refer to the Installing the Button Trim Ring section on
page 26 for more detailed faceplate installation information.
FIG. 6 Removing/installing a Compact Flash Memory card
Card removal
grooves
Insert with arrow
facing towards the pins
On-board Compact
Flash connector (with pins)
Connector opening
Any new internal card upgrade is detected by the panel only after power is cycled.