Filter
Top Products
Introduction
4
NXD-700Vi 7" Modero® Wall/Flush Mount Touch Panel with Intercom
NXD-700Vi Specifications
The following table outlines the specifications for the 7" Widescreen Modero panels.
Product Specifications
Dimensions (HWD): • NXA-RK7: metal rack-mount with black matte finish:
(4 RU - rack units high)
6.97" x 19.0" x 0.50" (17.70 cm x 48.26 cm x 1.27 cm)
• NXD-700Vi (with faceplate): 5.93" x 7.87" x 3.28"
(15.06 cm x 20.00 cm x 8.33 cm)
• CB-TP7 Conduit/Wallbox (optional): 5.47" x 7.23" x 3.40"
(13.90 cm x 18.40 cm x 8.64 cm)
Power Requirements
(stand-alone NXD-700Vi):
• Constant current draw: 1.1 A @ 12 VDC (stand-alone)
• Startup current draw: 1.6 A @ 12 VDC (stand-alone)
Memory (factory default): • 64 MB SDRAM
• 128 MB Compact Flash (upgradeable to 1 GB - factory programmed)
Weight (stand-alone): • NXD-700Vi: 4.12 lbs (1.87 kg)
Certifications: • FCC Part 15 Class B and CE
• IEC60950
Panel LCD Parameters: • Aspect ratio: 16 x 9
• Brightness (luminance): 350 cd/m
2
• Channel transparency: 8-bit Alpha blending
• Contrast ratio: 200:1
• Display colors: 256 thousand colors (18-bit color depth)
• Dot/pixel pitch: 0.19 mm
• Panel type: TFT Color Active-Matrix
• Screen resolution: 800 x 480 pixels (HV) @ 60 Hz frame frequency
• Video format: NTSC, PAL, and SECAM
• Viewing angles (100° total viewing angle):
Vertical: + 50° (up from center) and - 50° (down from center)
Active Screen Area: • 6.00" x 3.60" (15.24cm x 9.14cm)
IR Reception Angle: • Horizontal: +
50° (left and right from center)
• Vertical: +
30° (up and down from center)
Supported Audio Sample
Rates:
• 48000Hz, 44100Hz, 32000Hz, 24000Hz, 22050Hz, 16000Hz, 12000Hz,
11025Hz, and 8000Hz.
Front Panel Components:
Light sensor: • Photosensitive light detector for automatic adjustment of the panel brightness
(a dim room results in a dimmer LCD display, and a bright room results in a
brighter LCD display).
Note: The light sensor can be adjusted via the Sensor Setup page (page 110).
Motion sensor (PIR): • Proximity Infrared Detector to wake the panel when the panel is approached.
• Activation range: +
45° (left and right from center) and + 20° (up and down
from center).
Note: This sensor can be adjusted via the Sensor Setup page (see page 110).
IR Receiver: • IR reception: 38 KHz IR frequency.
• The IR receiver is located beneath the translucent Front Setup button. When
an IR code is detected it is sent to the NetLinx Master as a push on the
appropriate AMX IR channel.
• IR receivers and transmitters on G4 panels share the device address number
of the panel.