Filter
Top Products
2. Release
(ON1.
3. Touch
w.j
.
The built-in clock and any set daily alarms are reset.
l Do not touch
I-]
in step 3. Doing so will delete all
data in the unit.
l
However, if you have forgotten the password to be
entered in the start-up display, you have no choice but
to touch
I]
, losing all your data, to be-able to use
the unit.
D. Troubleshooting
Refer to the list below for solutions when the unit is not
functioning properly before contacting your local SHARP
dealer.
I
Problem
The display remains
blank after pressing
0
ON .
Poor display contrast.
The unit is turned on,
but pressing keys and
touch buttons has no
effect.
“Not enough memory”
displayed.
Solution
l
Set the card lock switch to LOCK.
l
Adjust the LCD contrast (see
p.
52).
l
Install new batteries (see
p.
302).
Adjust the LCD contrast (see p. 52).
41
The unit’s memory is full or nearly full.
Delete unnecessary data or install a
RAM card (see p. 238). (You can
check the amount of free memory
using CHECK MEMORY in the
TOOLS
menu. See p. 81.)
300