Filter
Top Products
63
Configuring the conference system
To switch the test mode off:
̈ Click “Test LEDs OFF”.
The indicators and displays of the initialized conference units go off.
Initializing the conference units with the access point – “Init Units“
There are two ways to initialize the conference units with the access point:
• automatic initialization – “Open access“
• manual initialization – “Manual” (recommended when operating
several WiCOS conference systems simultaneously and/or conference
systems with encryption)
̈ In the main navigation, click “Conference management” > “Init units”.
The “Init units” overview screen appears.
The following information is displayed:
To automatically initialize all conference units within the transmission
range of the access point:
̈ In the “Init Control” box, select the “Open Access” option button.
If you switch on a conference unit that is within the transmission range
of the access point, the conference unit is automatically integrated into
the conferences system. This conference unit is listed under “Units
Initialized” and “Unit monitoring”.
Information Function/Meaning
“Units initialized“ Number of conference units that are initialized with the
access point and currently switched on
“Units in Init List“ Number of conference units that are manually initialized
with the access point
CAUTION! Intermodulations in conferences!
If you operate several conference systems simultaneously in
“Open Access” mode, this will cause intermodulations as the
conference units will communicate with different access
points.
̈ Initialize the conference units manually (see next section).