Filter
Top Products
23
Putting the conference system into operation
̈ Connect the network cable to your computer or network.
̈ Call up the web server (see page 45).
Connecting a system cable for integrated operation
To integrate the WiCOS conference system into a wired SDC 8200
conference and interpretation system:
̈ Connect a system cable (Sennheiser SDC CBL RJ45, see “Accessories
and spare parts” on page 83) to the IN system socket (RJ 45) j.
̈ Connect the system cable to one of the six RJ 45 sockets (“PORT 1-6”)
of the SDC
8200 CU-M or SDC 8200 CU central unit (see page 70 and
the instruction manual of the SDC 8200 conference and interpretation
system).
Setting up the access point
̈ If possible, set up the devices so that there is a “free line of sight”
between the conference units and the access point.
To obtain the optimum transmission range:
̈ Place the access point as centrally and as high as possible.
j
SDC 8200 CU
Accesspoint
WiCOS AP
j
PORT 1-6
CAUTION! Danger of intermodulation!
If you set up the individual components of the conference
system too close to one another, intermodulation can occur.
̈ Observe a minimum distance of 1.5 m between the access
point and the conference units.
̈ Observe a minimum distance of 50 cm between the
conference units.