Sennheiser WiCOS Conference Phone User Manual


 
35
Running a conference
Connecting headphones (WiCOS CV and WiCOS DV only)
You can listen to the floor channel or the offered interpretation channels
(where applies) via headphones (see next section).
̈ Connect headphones with a 3.5 mm jack plug to one of the headphone
sockets
J.
You can connect mono or stereo headphones.
Listening to simultaneous interpretation (WiCOS CV and WiCOS DV only)
In order for you to be able to listen to a simultaneous interpretation of the
floor channel via headphones, the conference system has to be connected
to an interpretation system (see
page 73).
̈ Ask the organizer on which channel your desired language is
transmitted.
̈ Connect headphones to your conference unit (see above).
̈ Press the CHANNEL UP key F or the CHANNEL DOWN key G to select
the desired interpretation channel.
The selected interpretation channel is output via your headphones. The
channel selection display
E shows the currently set channel, e.g. “07
ENG” for channel 07 with interpretation into English (depending of the
configuration of the interpretation system). If you select “00 FLOOR”,
the floor channel will be output (factory default setting).
Adjusting the headphone volume
̈ Put the headphones on.
J
J
C CV D DV
G
E
F
C CV D DV
If the channel selection display E is showing a voting result, you
can return to the channel display view by pressing the
CHANNEL
UP key F or the CHANNEL DOWN key G. The voting
result cannot be displayed again.
CAUTION! Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
̈ Before putting the headphones on, set the volume to a
minimum level.
̈ Do not continuously expose yourself to high volumes.