Filter
Top Products
57
Configuring the conference system
Adjusting the conference settings –
“Conference Management“
Setting the maximum number of simultaneously active microphones
(speaker limit)
The speaker limit determines the maximum number of speakers who can
take the floor simultaneously. In the conference modes “FIFO” and “Group
1-4”, the speaker limit is preset to a fixed value.
̈ In the main navigation, click “Conference management”.
The “General Conference Settings” overview screen appears.
Color of bar Radio traffic
green No radio traffic on the corresponding frequency:
Your conference system should use this frequency.
red Heavy radio traffic on the corresponding frequency:
Your conference system should not use this frequency.
If you have manually set your conference system to a frequency
range, it might be that the frequency range monitoring displays the
radio traffic of the set frequency range that is used by the
conference system itself.
This does not impair the operation of the conference system.
If you have integrated the WiCOS conference system into the wired
SDC
8200 conference and interpretation system, the conference
settings can be configured via the central unit of the wired system
(see
page 73 and the instruction manual of the SDC 8200
conference and interpretation system).
If you set a high number of interpretation channels, the speaker
limit will be reduced.
̈ Reduce the number of interpretations channels in order to be
able to set the speaker limit to a maximum of 8 (
see “Setting
the number of interpretation channels” on page 60).