Filter
Top Products
45
Configuring the conference system
After the reset, the following factory default settings are loaded:
Calling up the web server of the access point
In order to be able to call up the web server of the access point, you require
a computer with network connection (RJ
45) and a web browser.
̈ Make sure that the access point is correctly connected to your
computer or network via the network socket
(RJ 45) h.
Setting the computer to the address range of the access point
In order to access the web server the first time, you have to set your
computer to the address range of the access point.
Configuration Factory default setting
Network settings
(IP address)
System name: “WiCOS“
IP address mode: “Static“
IP: “192.168.0.10“
Subnet: “255.255.255.0“
Password protection “123“
RF signal strength (“Room size“) “Big“
Radio frequency “Automatically“
Country settings for radio communication
(“Country selection“)
“US/Canada“
Max. number of simultaneously
active microphones
“4“
Conference mode “Direct Access“
Loudspeaker volume “6“
Number of interpretation channels “0“
Operating mode of the chairman units
WiCOS
C and WiCOS CV
“Volume Control“
Operating mode of the access point “Stand Alone“
Initialization mode of the conference
units
“Open Access“
Encryption mode “Use default key“
You only require the fixed IP address of your computer in order to
access the web server for the first time. Via the web server, you can
adapt the IP address of the access point to match the ones in your
network.