Filter
Top Products
Running a conference
42
̈ Press the
– selection key A 8 to increase the loudspeaker volume or
– selection key B 9 to reduce the loudspeaker volume.
The loudspeaker volume is changed. As long as you keep the key 8 or
9 pressed, the LED next to the key lights up.
Activating the media control mode
In the future, the WiCOS C and WiCOS CV chairman units will allow you to
transmit commands to a media control system, for example in order to
trigger circuits via a home controller. The corresponding commands can be
programmed via the web server of the access point.
If you are using the WiCOS CV chairman unit, activate the media control
mode as follows (e.g. to start or stop a camera system):
̈ Keep the ABSTAIN key C pressed until the “media control mode” is
shown on the multi-function display
7.
The multi-function display switches between “voting mode”, “volume
adjustment mode for loudspeakers” and “media control mode”.
̈ Press the selection key A 8 or the selection key B 9 to trigger circuits
via a home controller.
Depending on the setting, pressing key 8 or 9 transmits a start signal
or a stop signal.
If you are using the WiCOS C chairman unit:
̈ Via the web server, set the function of the selection key A 8 and B 9
to “Function key” (see page 65).
9
8
C CV D DV
The volume of the conference units’ loudspeakers can also be
adjusted via the web server of the access point (see
page 59).
C
7
C CV D DV
7
You can also switch between the operating modes using the
web server (see
page 65).
9
8
C CV D DV